Smart homeHubs & platforms · Lighting & switches · Sensors · Automation & scenes · Voice assistants & displays
Climate & airThermostats · Heat pumps · Air quality · Mini splits · Ventilation · Humidity control
Power & energyBackup power · EV charging · Energy monitoring · Solar & inverters · Generators
Security & accessSmart locks · Cameras & doorbells · Alarm systems · Garage & access
Water protectionLeak detection & shutoff · Water heaters · Sump monitoring
Networking & electricalHome networking · Smart panels · Structured wiring
Installation & interoperabilityWiring requirements · Professional installation · Maintenance & warranties
  1. Home
  2. Buying guides
  3. Home Battery vs Generator vs Portable Power Station
Backup power

Home Battery vs Generator vs Portable Power Station

Backup power compared: home batteries, standby and portable generators, and power stations, by capacity, runtime, transfer method, noise, safety and cost.

Quick answer

A home battery stores 10 to 15 kWh or more per unit, switches over silently and pairs with solar, but runtime is limited by capacity. A standby generator runs on natural gas or propane for days and starts automatically. A portable generator is cheapest per watt but must run outdoors and connect through a transfer switch or interlock. A power station suits a few essentials. Size any of them to your critical loads.

The right backup depends on what you need to keep running and for how long. Start with a list of essential loads, then compare systems.

Side by side

Home battery Standby generator Portable generator Power station
Energy About 10 to 15 kWh per unit, expandable Unlimited while fuel lasts Limited by tank size About 1 to 5 kWh
Switchover Automatic, near seamless Automatic, seconds Manual Manual
Fuel Grid or solar Natural gas or propane Gasoline, propane or dual fuel Grid, solar or car
Noise Silent Moderate Loud Silent
Indoor use Yes, per install code No, outdoor unit Never Yes
Connection Installed with panel or gateway Automatic transfer switch Transfer switch or interlock Cords, or a transfer panel on some models

Size your loads

Load Typical running watts
Refrigerator 100 to 800 (cycles on and off)
Furnace blower 300 to 800
Sump pump 800 to 1,500
Well pump 1,000 to 2,500
Internet and router 20 to 60
LED lights 10 each

Motors draw a surge at start-up two to three times their running watts. Check the nameplates on your appliances.

Safety and certification

Look for UL 9540 listing on home battery systems and UL 1741 on inverters. Generators must connect through a transfer switch or interlock; never backfeed. Portable generators should have CO shutoff and run outdoors.

Which to choose

Choose a battery if you have or plan solar and want silent, automatic backup. Choose a standby generator for long outages with natural gas available. Choose a portable generator for cost, accepting manual setup. Choose a power station for apartments or a short list of devices.

EV owners should also read our Level 2 charger guide for panel capacity. Browse power and energy.

Common questions

How much backup power do I need?

List the loads you must run, add their watts for peak power and multiply by hours for energy. A fridge, lights, internet and a furnace blower need far less than a whole house.

Can I plug a portable generator into a wall outlet?

No. Backfeeding through an outlet is dangerous and illegal. Use a transfer switch or an approved interlock installed by an electrician.

Where should a portable generator run?

Outdoors, well away from doors, windows and vents. The CDC advises at least 20 feet from the home because of carbon monoxide.

Does a home battery work without solar?

Yes. It charges from the grid and covers outages, though solar lets it recharge during a long outage.